Panasonic CDR-574 CD-ROM Driver (IDE Interface)
QUAD SPEED IDE CD-ROM DRIVE
===============================================

/D:xxxxxxx    ---> Device name option
                   ex.)DEVICEHIGH=[path]\CR_ATAPI.SYS /D:CDROMDRV

/P:nnn        ---> ATAPI base I/O Port Address(hex) option
                   ex.)DEVICEHIGH=[path]\CR_ATAPI.SYS /D:MSCD000 /P:nnn
                   nnn==1F0, 170, 1E8 or 168
                   Primary connection: /P:1F0
                   Secondary connection:   /P:170
                   Tertiary connection:    /P:1E8(Sound Blaster IDE)
                   Quaternary connection:  /P:168(Sound Blaster IDE)

/I:xx         ---> Interrupt number option
                   ex.)DEVICE=CR_ATAPI.SYS /D:MSCD000 /I:xx
                   Primary connection: xx==/I:14
                   Secondary connection:   xx==/I:15
                   If you use Sound Blaster IDE, please set following
                   Tertiary connection:    xx==/I:10,11,12,14 or 15
                   Quaternary connection:  xx==/I:10,11,12,14 or 15

/W:n          ---> Waiting value option
                   When PC read data from CD-ROM drive, Driver insert waiting
                   value into read cycle one by one.
                   If you are using PC that are not supported IOCHRDY, please set
                   this value(waiting value).
                   ex.)DEVICEHIGH=CR_ATAPI.SYS /D:MSCD000 /W:n
                   n==0, 1, 2, ... 255
                   (106usec/1 wait in 486DX2 66MHz)

/Q            ---> Non stop option
                   Non stop(no message <A>bort, <R>etry) in initializing driver.
                   ex.)DEVICEHIGH=CR_ATAPI.SYS /D:MSCD000 /Q