================================================================
Readme for ATAPI CD-ROM Drives with all current versions of  DOS and
Windows 3.X.
================================================================
To install this device driver for the DOS\Windows operating systems,
please follow this procedure:

Note: If you have DOS 5.0 or a previous version of DOS, you will
need to obtain a copy of the Microsoft file: "MSCDEX.EXE."

DOS version  6.0  or higher  will display a "Wrong DOS Version"
error if you use the MSCDEX.EXE file from a lower version of
DOS.  Please insure that you use the  correct version of
MSCDEX.EXE with your DOS operating system.

The MSCDEX.EXE  file is used in AUTOEXEC.BAT  to assign a drive
letter for your CD-ROM drive

To install the ATAPI device driver, type the following command at
the C:\temp prompt:

C:\temp> SETUP.BAT

Please accept the default responses to questions in the SETUP.BAT
installation procedure.  SETUP.BAT will create a DEV
directory and copy TAISATAP.SYS to it.  Setup will also
create a BIN directory and copy MSCDEX.EXE to it.  Next,
Setup will modify the CONFIG.SYS and AUTOEXEC.BAT files to
include the required lines for the CD-ROM drive.

Reboot the system, and the CD-ROM should be recognized and will be
assigned the next logical drive letter after your hard
drive(s).


================================================================
Device driver installation for MS-DOS mode, under Windows `95  -
(Real Mode Drivers)
================================================================
First , Click the Windows `95, "START" button, then select  "Restart
the computer in MS-DOS mode".

The DOS command prompt will be displayed.  ex:

C:\WINDOWS>

To install the ATAPI device driver, type the following commands:

C:\DOS> CD \temp
C:\temp> SETUP.BAT

Please accept the default responses to questions in the SETUP.BAT
installation procedure.  SETUP.BAT will create a DEV
directory and copy TAISATAP.SYS to it.  Setup will also
create a BIN directory and copy MSCDEX.EXE to it.  Next,
Setup will modify the CONFIG.SYS and AUTOEXEC.BAT files to
include the required lines for the CD-ROM drive.

When finished with the setup program  you must "EXIT"  back to
Windows 95.  Then click on Start, shut down and Restart in
MS-DOS mode,  for the drivers to become active. When you do
this you will see a drive letter assigned.

After completing this procedure, your CD-ROM drive will be
recognized in both Windows `95 and MS-DOS modes each time
your system comes up.

If you have problems with  the above procedures, please call our
technical support group at (714) 455-0407, select option #1
for assistance.